Steering stem nut cap removal?

[taxonomy]

I just looked at a parts diagram and found that the steering stem nut (center of the triple trees) has a plastic cap on it.  I thought this was integrated into the nut. 

Anyhow, I want to remove this cap top gain access to the steering stem as a place to put at RAM mount so I can run a GPS or radar detector (or anything else there, I guess) It's not immediately obvious how to get this plastic cover out.

Any tips?

[a_morti]

It's just wedged in. You can get it out easiest from the inside by taking the nut off.

[Kai Ju]

Actually, if I remember correctly just take a long screwdriver/rod and push it out from the bottom, i.e up the steering stem from the lower triple tree.

[taxonomy]

Thanks all.   I just popped it out with a socket extension from the bottom.   I now have a very neat RAM mount in the hole for GPS or radar detector use.

[91cb-1]

Lets have a look then