.........engine bars.......

[Davie Thistle]

.......hulo people!
hope one or two of you can help! I've just bought bars to fit the CB1-400,
but in aligening them up, I couldn't see where to put them!
mibbees I'm beingt daft, but has anybuddy done this before and can advise? - Pics even!
thanx in anticipation!
D.T.

[clarkdw]

This help? I don't have any good pics of the other side but the locations are the same. You will probably find the lower rod supplied to be barely long enough. I eliminated the washers and used self locking nuts to get enough length.

[clarkdw]

.......hulo people!
hope one or two of you can help! I've just bought bars to fit the CB1-400,
but in aligening them up, I couldn't see where to put them!
mibbees I'm beingt daft, but has anybuddy done this before and can advise? - Pics even!
thanx in anticipation!
D.T.

Speaking of pics. How about some of your bike?

[Davie Thistle]

...excellent pic! thanx alot!

will get them done plus the screen, & post a pic asap,

[Davie Thistle]

...pic posted, thanx for the information and encouragement! clarkdw!!!

[wardy]

pleaes please please tell me where i can get some engine bars.............prety please

[clarkdw]

Looks like the source in Belgium that regularly listed them on ebay has dried up. I will keep an eye out for some. an alternative is to fit frame sliders (crash bobbins?) like ptlcb1 did. Check out his race bike pics. Might need to adapt with different bolts than those supplied but could be done.

[wardy]

yeah have thought about the sliders but to be honest with the work and money im puting into this bike im hoping not to crash, the bars would be as much for cosmetic reasons as protection as i think they would look brilliant powder coated along with the rest of the frame, thanks for looking tho