HondaCB1.org Message Forums

General Category => Photo Gallery => Topic started by: Spurlock on January 22, 2018, 10:42:24 PM



Title: First peek inside the valve cover
Post by: Spurlock on January 22, 2018, 10:42:24 PM
Today was wet and foggy, perfect for a nice shop project. So, shim kit in hand, I decided to check valve clearance on the CB-1 400 four. First things first, I got a good fire going in the wood stove to make sure my faithful companion Blondie was happy. She was.

(https://photos.smugmug.com/Misc/i-R8w9CLx/0/826dc235/O/DSC07995.jpg)

Then after pulling the tank, air box, plug wires, assorted hoses and the valve cover I got my first glimpse of the gear driven DOHC goodness. The split gears are slightly offset and spring loaded to take up gear lash to reduce noise.

(https://photos.smugmug.com/Motorcycles/CB-1/i-vFtLDh5/0/70a47209/O/DSC07983.jpg)

All 16 valves measured well within tolerance and were surprisingly consistent, even though it did not appear the valve cover had ever been off before.

(https://photos.smugmug.com/Motorcycles/CB-1/i-tD2Pzzp/0/b222ec2a/O/DSC07987.jpg)

It's interesting how the carburetors and intake manifolds aim in a straight line to the combustion chambers.

(https://photos.smugmug.com/Motorcycles/CB-1/i-FGDV5mv/0/8d250cff/O/DSC07997.jpg)


(https://photos.smugmug.com/Motorcycles/CB-1/i-CkkWZf2/0/b780750e/O/DSC08003.jpg)

I had pulled the valve cover off with the radiator hoses still in place which made it much harder. So to make sure the cam cover seal stayed in place on the way back together, I drained coolant and got all hoses out of the way. That made it much easier to put the cover back on.

(https://photos.smugmug.com/Motorcycles/CB-1/i-6ZRF78R/0/45e1fd6c/O/DSC08005.jpg)

After getting things all buttoned up, I'm looking forward to a ride as soon as the roads dry out.

(https://photos.smugmug.com/Motorcycles/CB-1/i-PdSSS6P/0/5445899f/O/DSC07970.jpg)

-Bill


Title: Re: First peek inside the valve cover
Post by: a_morti on January 23, 2018, 02:02:10 AM
Your bike is in amazing condition.

Your little pal is a looker. Do we need a pets thread?


Title: Re: First peek inside the valve cover
Post by: See Bee-Won on January 24, 2018, 07:03:18 PM
You lucked out. I had a few tight clearances on my first valve check. Second time everything was within spec. Many times you can swap around shims without even replacing any. Have a notepad, pen, egg carton, and calculator handy. Organization and patience is key. One of those jobs where you wish you wouldn't of slept through H.S. math class.  ;D


Title: First peek inside the valve cover
Post by: crorembere on October 04, 2018, 09:24:30 AM
nice one sir..
places to visit.
onboard shots.
before and after shots of modded bikes?